Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.     

Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

US-UV-Fenton降解硝基苯

采用超声波(US)、紫外光(UV)和Fenton联合降解硝基苯,初步探讨了其作用规律。研究结果表明,UV可以促进双氧水转化自由基的效率,而US同时具有强化传质作用和超声氧化作用,两者均能够强化Fenton氧化硝基苯的降解过程。正交实验结果表明,H2O2初始浓度是硝基苯降解和矿化的最显著影响因素,反应时间和超声功率是矿化的显著影响因素。最佳反应条件为:H2O2500 mg/L、Fe2+10 mg/L、反应时间60 min、超声波功率100 W,此时,硝基苯完全降解,TOC去除率达到73.0%。Fenton、UV/Fenton和US/UV/Fenton降解硝基苯过程均符合伪一级反应动力学模式,反应速率常数分别为3.37×10-2、3.81×10-2和5.10×10-2min-1。     

锰铜铈氧化物催化剂氧化NO性能及动力学研究

实验以TiO2为载体采用浸渍法制备CuOx/TiO2、CeOx/TiO2、CuCeOx/TiO2和MnCuCeOx/TiO2催化剂,考察这些催化剂氧化NO活性,探究Cu、Ce摩尔比和添加Mn元素对CuCeOx/TiO2催化剂氧化NO活性的影响,使用扫描电镜观察催化剂表面结构。研究发现,Cu、Ce元素配合后的CuCeOx/TiO2催化剂氧化活性明显好于单独含Cu、Ce的催化剂,当Cu、Ce摩尔比为Cu:Ce=1∶2时,CuCeOx/TiO2催化剂氧化活性最好,在NO浓度500×10-6,O210%,空速为24 000 h-1,350℃时,NO氧化度为0.62;添加Mn元素可以提高CuCeOx/TiO2催化剂低温氧化活性,250℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度为0.53和0.69,300℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度均为0.76;此外,实验还研究了NO在MnCuCe/Ti-3催化剂上反应的动力学方程。     

Nitrogen enrichment in runoff sediments as affected by soil texture in Beijing mountain area

Enrichment ratio (ER) is widely used in nonpoint source pollution models to estimate the nutrient loss associated with soil erosion. The objective of this study was to determine the ER of total nitrogen (ER_N) in the sediments eroded from the typical soils with varying soil textures in Beijing mountain area. Each of the four soils was packed into a 40 by 30 by 15 cm soil pan and received 40-min simulated rainfalls at the intensity of 90 mm h^?1 on five slopes. ER_N for most sediments were above unity, indicating the common occurrence of nitrogen enrichment accompanied with soil erosion in Beijing mountain area. Soil texture was not the only factor that influenced N enrichment in this experiment since the ER_N for the two fine-textured soils were not always lower. Soil properties such as soil structure might exert a more important influence in some circumstances. The selective erosion of clay particles was the main reason for N enrichment, as implied by the significant positive correlation between the ER of total nitrogen and clay fraction in eroded sediments. Significant regression equations between ER_N and sediment yield were obtained for two pairs of soils, which were artificially categorized by soil texture. The one for fine-textured soils had greater intercept and more negative slope. Thus, the initially higher ER_N would be lower than that for the other two soils with coarser texture once the sediment yield exceeded 629 kg ha^?1.     

Carbon Sequestration Function of Check-Dams: A Case Study of the Loess Plateau in China

Check-dams are the most common structures for controlling soil erosion in the Loess Plateau. However, the effect of check-dams on carbon sequestration, along with sediment transport and deposition, has not been assessed over large areas. In this study, we evaluated the carbon sequestration function of check-dams in the Loess Plateau. The results indicate that there were approximately 11 000 check-dams distributed in the Loess Plateau, with an estimate of the amount of sediment of 21 × 10⁹ m³ and a soil organic carbon storage amount of 0.945 Pg. Our study reveals that check-dams in the Loess Plateau not only conserve soil and water but also sequester carbon.     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

Bibliometric analysis of simulated driving research from 1997 to 2016

Objective: The objective of this study was to explore the evolution footprints of simulated driving research in the past 20 years through rigorous and systematic bibliometric analysis, to provide insights regarding when and where the research was performed and by whom and how the mainstream content evolved over the years.

Methods: The analysis began with data retrieval in Web of Science with defined search terms related to simulated driving. BibExcel and CiteSpace were employed to conduct the performance analysis and co-citation network analysis; that is, probe of the performance of institutes, journals, authors, and research hotspots.

Results: A total of 3,766 documents were filtered out and presented an exponential growth from 1997 to 2016. The United States contributed the most publications as well as international collaborations followed by Germany and China. In addition, several universities in The Netherlands and the United States dominated the list of contributing institutes. The leading journals were in transportation and ergonomics. The leading researchers were also recognized among the 8,721 contributing authors, such as J. D. Lee, D. L. Fisher, J. H. Kim, and K. A. Brookhuis. Finally, the co-citation analysis illuminated the evolution of simulated driving research that covered the following topics roughly in chronological order: task-induced stress, drivers with neurological disorders, alertness and sleepiness while driving, trust toward driving assistance systems, driver distraction, the effect of drug use, the validity of simulators, and automated driving.

Conclusions: This article employed bibliometric tools to probe the contributing countries, institutes, journals, authors, and mainstream hotspots of simulated driving research in the past 20 years. A systematic bibliometric analysis of this field will help researchers realize the panorama of global simulated driving and establish future research directions.     

气浮技术在膜生物反应器剩余污泥浓缩过程中的应用

污泥浓缩作为污泥处理的关键环节之一,开发高效的污泥浓缩工艺对于降低污泥含水率、提高脱水设备的运行效率、降低脱水能耗具有十分重要的意义。针对MBR污泥浓度高、污泥粒径小、污泥沉降性能较差等特点,故采用传统的重力浓缩和机械浓缩技术很难有效实现污泥浓缩。因此,尝试采用气浮浓缩技术降低污泥含水率的可行性。从气浮浓缩的中试结果来看,较适宜运行参数为:固体负荷为15 kg/(m2·h),水力负荷为1.5 m3/(m2·h),回流比为1,PAM投配率2‰(w/w干固体),溶气压力为0.4 MPa,气固比为0.03。经过中试设备进行气浮浓缩后,污泥含水率降低至96%左右。此外,还研究了采用气液多相泵系统对剩余污泥的浓缩效率,结果显示,该设备的使用相对于传统溶气气浮工艺,其优点表现在占地小、工程造价低以及运行成本低等方面。     

改性壳聚糖复合凹凸棒土絮凝油漆废水

将壳聚糖、阳离子淀粉和二甲基二烯丙基氯化铵(DMDAAC)进行三元接枝共聚,制备了三元接枝改性壳聚糖(CTS-DMDAAC-CS),通过红外光谱和扫描电镜对其结构进行了表征。并且将三元接枝改性壳聚糖与凹凸棒土进行优化复配,对油漆废水进行了絮凝实验,得出了当pH=12,沉降时间为20 min,复合絮凝剂投加量为0.2 g,三元接枝共聚物∶凹凸棒土=1∶10时,该复合絮凝剂对油漆去除率最佳能够达到89.3%,并且絮凝效果好,是一种新型绿色环保的有机-无机复合絮凝剂。